Forum | Appery.io

I have followed both tutorials about geolocation. And also looked in history. But nothing helps.
When I test my app in my computer, it shows my location, but when I use the Appery.io tester & APK installed in phone shows and unknown place " Ace lock service inc" location.
I of course have gps turn on. and have chosen device for geolocation service.
When I tested the APP, reading the QR directly from the tester icon, the app lounched and ask me to accept that Appery wants to know my location. I accept, and it showed my exact location.
But it always fails on tester APP, and APK installed!
any idea? thanks!!

Hello,

When you running app in Appery.io tester do you get any errors?
On what device/Android version do you run app?
Please share app with a href="mailto:support@appery.io" rel="nofollow"support@appery.io/a, tell its name and steps to test.

hello Alena,

No, I dont have any errors. Just when I click map, it shows the location mentioned above.
the device is sony xperia android version 2.3.7.
Ok, I ́ll share de app. name is phoswipe, its a 3 page APP. Screen 1 has the push notification tutorial, and there ́s a button named "mapas" wich takes you to the actual map.

I ́m also having problems with push notifications, I follow the tutorials, and when I install the APK in my phone, initialize changes to DONE, as well as register, but notificion never arrives nor the message.

could you help me with these two issues?

thanks in advance.

Thank you for sharing. We'll take a look. Regarding Push notifications - see my reply here https://getsatisfaction.com/apperyio/...

Hello! Timeout is triggered before you recieve data. Common sources of location information include Global Positioning System (GPS) and aGPS (location inferred from network signals such as IP address, RFID, WiFi and Bluetooth MAC addresses, and GSM/CDMA cell IDs). aGPS is not supported for all devices, it returns data quickly but it's not accurate. If that's ok for you on Screen2 screen in geolocation1 service mapping on Request parameters tab set enableHighAccuracy = false. If you need accurate data note that you can recieve it after 1-2 minutes. That means you have to set timeout to 600000 (600000 is 10 minutes - just adding some additional time), leave enableHighAccuracy = true.

Great! I just change the value of HighAccuracy to FALSE and it works!
Thanks Again!

Hi Maryna,

Out of curiosity, how did you find out about the timeout? Had the same problem and was wondering how to debug such problem?

Thank you, and thanks for the solution!

Richard

Hello! We had added alerts on service events (success, fail) and found fail event is triggered on specified timeout.

Hi, i have what i think is this same problem... but i ́m not able to change the value of parameters on request service ( i can read but not write?).

Can you help me ?
Thanks

I ́m sorry ... i was trying to change on service and not on the request itself

But i still have an issue...

I can get my geolocation on a LazerX40e , but not on huawei ascend g510 ... What can it be ? All settings are the same and the apk too.
Thanks