Page 1 of 1

Preview not in line with current saved work

Posted: Sun Jan 20, 2013 7:22 pm
by Kirk Wilson

Hello,

I recently lost all pages that I was working on, this is not my problem however it may be related. I was able to rebuild one of the pages and prefer this one over the old ones, my problem is when I try and preview my new page now it shows the old pages that where lost.

Any help with this would be appreciated.

Kirk


Preview not in line with current saved work

Posted: Mon Jan 21, 2013 6:17 am
by Maryna Brodina

Hello! Could you clarify please how did you lost your pages? If I understand you correctly that pages are not present in your project now, but you can see them on preview?


Preview not in line with current saved work

Posted: Mon Jan 21, 2013 9:03 am
by Kirk Wilson

Hello, yes ill explain a bit better. Its was when I logged in the pages where gone, all the other resources where still there however, my browser (chrome) had just stopped responding on your main page so I did a restart, I had saved previously. I wasn't to worried as I am still finding my feet with the software so I started again from scratch, but now when I preview the pages that went missing are showing up.


Preview not in line with current saved work

Posted: Mon Jan 21, 2013 9:21 am
by Maryna Brodina

Preview not in line with current saved work

Posted: Mon Jan 21, 2013 12:09 pm
by Kirk Wilson

I am away all day today but will share later tonight, sorry for the delay and thanks for the help so far


Preview not in line with current saved work

Posted: Mon Jan 21, 2013 12:11 pm
by Maryna Brodina

No worries:) Waiting for your project.


Preview not in line with current saved work

Posted: Mon Jan 21, 2013 10:52 pm
by Kirk Wilson

That is is the project shared with support@tiggzi.com


Preview not in line with current saved work

Posted: Tue Jan 22, 2013 10:02 am
by Kateryna Grynko

Hello,
There was some Tiggzi problem.
We've fixed your project. There are two screens now.


Preview not in line with current saved work

Posted: Tue Jan 22, 2013 10:59 am
by Kirk Wilson

Thank you, all is working again.