Trying to change the the push sender id and key in app settings.
After entering new values. Save project.
re-open project but the setting remain the previous values.
Push setting not saved
Push setting not saved
Ah. Found my problem.
Copy and paste does NOT work.
While the values are pasted and closing-re-open setting tab shows the new pasted values.
Problem is its not registered as a change so when saving project this does not get updated.
To prevent this I just pressed spacebar after entering values, backspace Then saved ok.
As these are very large numbers I would suggest changing this functionality. Because im sure everyone pastes this data.
Push setting not saved
Can you post the exact steps? I have seen a similar problem but it was only reproduced in Chrome, on Ubuntu.