Forum | Appery.io

Trying to change the the push sender id and key in app settings.
After entering new values. Save project.
re-open project but the setting remain the previous values.

Ah. Found my problem.
Copy and paste does NOT work.
While the values are pasted and closing-re-open setting tab shows the new pasted values.
Problem is its not registered as a change so when saving project this does not get updated.
To prevent this I just pressed spacebar after entering values, backspace Then saved ok.

As these are very large numbers I would suggest changing this functionality. Because im sure everyone pastes this data.

Can you post the exact steps? I have seen a similar problem but it was only reproduced in Chrome, on Ubuntu.